The amount of electricity generated by the solar panel power generation = 1/3 of the total power consumption of electrical appliances, the amount of electricity provided by wind power generation = 2/3 of the total power consumption of electrical appliances
1. Calculating method of pure solar energy circuit lamp (or system)
The average hours of sunshine in the northern hemisphere is 4-6 hours.
Solar panel power = (electrical power W × time H) ÷ local peak hours of sunshine hours H × loss factor (1.6 ~ 2)
Battery capacity = (electrical power W × time H) ÷ system voltage V × number of rainy days × loss factor (1.4 ~ 1.8)
Controller current A = solar panel power W ÷ charge voltage V
2. Computation method of solar wind complementary circuit lamp (or system)
Generally, the wind power level in the northern hemisphere starts from level 3, which is 5 meters per second, and the daily power generation time is 6-12 hours.
Total power consumption of electrical appliances = Electrical appliance power W × Time H = WH kWh (degrees)
Areas where solar energy resources are preferred will supplement wind power.
The amount of electricity provided by solar panels to generate electricity = 2/3 of the total electricity used by appliances,
Electricity generated by wind power = 1 / 3 total electricity consumption
Areas with a preference for wind resources supplement solar energy.
The amount of electricity generated by the solar panel power generation = 1/3 of the total power consumption of electrical appliances, the amount of electricity provided by wind power generation = 2/3 of the total power consumption of electrical appliances
TPO Membrane Weld Plates are available for use with TPO membranes. Suitable for rigid substrates such as gypsum board, cement board, etc., then induction welded with thin films to form non-vertical connections to resist wind loads. Plate diameter: 80mm;Hole diameter: 6.8mm. Color: Front side: Light green;Back side: Epoxy light brown/light grey/Or anti-finger print alu-zinc film. FM approved.
Galvalume Steel Round Barbed Plates are made of aluminum plus galvanized steel. The plate's rounded design and stiffening ribs provide excellent strength against the lifting forces of the wind. SRD (60 mm) seam plates are used for lap seam fastening. SRD (73 mm) insulating plates are used to fasten the insulation. These panels are designed to be insulated for use with fasteners in TPO/PVC roofing systems with ply-Iso. FM approved.
Plates & Screws,Sealant For Door,Metal Plates And Screws,Water Resistant Building Materials
Suzhou Smart Building New Materials Co., Ltd. , https://www.srdwaterproofing.com