| Home>Bearing knowledge>What are the methods for disassembling common rolling bearings? |
What are the methods for dismantling commonly used rolling bearings?
Source: China Bearing Network Time: 2014-07-29
| /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
First, the tapping force is usually added to the inner ring of the bearing; the striking force should not be added to the rolling body and the supporting frame of the bearing; this method is simple and easy; but the bearing is simply damaged; when the bearing is at the end of the shaft; Use a copper rod or other soft metal material that is smaller than the inner diameter of the bearing to abut the shaft end; the lower part of the bearing is padded; the hammer is slammed by hand; it can be removed. This method should be used to pay attention to the orientation of the spacer; It should be correct.
Second, the pull-out method selects the special puller; when disassembling; just rotate the handle; the bearing will be pulled out gradually. When the outer ring of the bearing is disassembled; the angle of the two legs of the puller should be opened outward, and the inner ring of the bearing is opened. When the puller two feet should be inward; stuck on the end face of the bearing inner ring.
Matters needing attention:
1. Hook the puller of the puller to the inner ring of the bearing; instead of hooking it on the outer ring; avoid excessive looseness or damage of the bearing.
2. When using the puller; align the Screw to the middle hole of the shaft; do not tilt. Also pay attention to the force of the hook and the bearing; do not damage the hook and the bearing.
3, pay attention to avoid the hook slip,
4, the angle of the two feet of the puller is less than 90 °.
Third, the push method uses a press to push the bearing; the operation is stable and reliable; does not damage the machine and the bearing. The press has manual pushing; the mechanical or hydraulic press pushes.
Matters needing attention: the focus of the press should be in the middle of the shaft;
4. The hot-disassembling method is used to disassemble the tightly-cooperative bearing. Firstly, the oil heated to about 100 °C is poured into the bearing to be disassembled; after the bearing ring is heated, the bearing can be pulled out with a puller. .
Matters needing attention:
1. First and foremost; the puller should be mounted on the bearing to be removed; and a certain pulling force should be applied.
2. Before heating; the shaft should be wrapped with asbestos rope or thin iron plate; avoid the shaft from being heated and expanded; otherwise it will be difficult to disassemble; when the bearing is removed from the bearing housing hole; only the bearing housing hole can be heated; Can't heat the bearing,
3. When pouring oil; the oil pot should be smoothly poured on the bearing ring or the rolling body; and an oil basin should be placed under it; collect the hot oil flowing down; avoid the dregs and burns,
4, the operator should wear asbestos gloves; avoid burns.
Recommend to friends comments close window
| Bearing related knowledge |
| Analyze the cause of damage to imported bearings The casting method of NTN bearing and the common terminology and definition of the target bearing industry (1) Timken thrust bearing analysis of oil-free bearings - mold professional needs |
This article links to http://
Please indicate the bearing network http://
Previous:How to clear the motor bearing Next: Analysis of the primary damage mode of the tumbling imported bearing
2 Pillow Block Bearing Sucfl204-212,Pillow Block Bearing Housing Sucfl204-212,Pillow Block Bearing Sucfl204-212 Sizes
Jiangsu Dingtian Stainless Steel Products Co., Ltd. , https://www.dingtiancasting.com