The second step: see if the tiles are deformed and measure whether the two diagonals of the tile are equal;
The third step is to look at the water absorption rate of the tiles. With water drops on the back of the brick, the smaller the diffusion area, the longer the drying time, the lower the water absorption rate, and the better the quality.
Step 4: Listen to the sound and tap the tile with your hand. The sharper the sound, the better the quality.
Step 5: Weigh the weight. The heavier the weight, the better the texture.
Step 6: Unpacking inspection, pumping one box of different box products, and see if there is any color difference after laying and whether the size is the size.
The laying of dry-laid floor tiles for floor tiles should theoretically use a dry-laid method to remove floating sand and debris after the roots are moistened with water. Wipe the bonding layer, use one to three dry cement mortar, lay flat according to the horizontal line, put the brick on the mortar and use the rubber-coated hammer to shake, remove the floor tile and pour the cement slurry, and then put the floor tile to make it level . The dry paving method effectively avoids the occurrence of air bubbles and empty drums caused by the paving of the floor tiles. However, because the dry paving method of the ground tiles is relatively labor-intensive and has a relatively high technical content, the general dry paving method is better than the wet paving method. The cost of the law is much higher.
The wet paving method is a method commonly used by many home improvement owners. The difference between this process and the dry paving method is to replace one to three dry cement mortars with ordinary water and cement mortar. The tiled floor using the wet paving method may generate hollow drums and air bubbles, which may affect the service life of the tile. However, due to the ease of operation and low price of the wet paving method, many families still use the wet paving method to lay the ground.
Tiles, tiles, tiles, home tiles, tiles, tiles, tiles
peristaltic hose pump could be used in lots industry . for example : filter press, catalyst industry,shield machine,construction industry , power conveying industry , animal husbandry application and so on . Concrete peristaltic hose pump ; High efficiency widely used concrete peristaltic Industrial Hose Pump ; Squeeze Industrial Hose Pump ; Rubber Hoses Transfering Corrosive Products hose peristaltic pump ; Heavy Duty Continuous Transfer Pump ; Wear-resistant rubber hose pump chemical peristaltic pump construction concrete pump
Hose pump have strong self priming, pump been used to transfer the liquid with big solid particles, like: Concrete, sludge, mud, Cow dung etc.
A wall smooth, reliable strength of special rubber hose inside the pump installation, by rotating the squeezing roller along the hose is a pair of such rotation makes medium to one direction, and there won't be back.Flattened hose under their own flexibility and side guide roller forced restorable. At this point, the tube materials materials will produce high vacuum suction cavity, and then, the material in the subsequent roller pressure escape from the hose.So the cycle, material overtaken by suction and discharge.
Peristaltic Hose Pump,Peristaltic Pump,Industrial Peristaltic Hose Pumps,Peristaltic Pump Tubing
Hengshui Yuanhan Trading Co.,Ltd , https://www.yuanhanpump.com