FAG active oiler

Source: Bearing network time: 2013-03-22

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

Rolling bearings for long-life operation are reliable mechanical parts. Most of the bearings are damaged because the smoothing method is not correct or the smoothness is not enough. About 90% of the bearings are smooth and the grease is smooth. Therefore, it is uniquely important to supply the smooth grease. of.
The use of active smoothing equipment enables the writing of clean and smooth grease to the part that is connected to the rolling bearing. The operating life of the bearing is greatly increased. The reliable and economical active oiling equipment prolongs the smoothing and protection cycle; avoids smooth grease Write too much or too little appearance. Then reduce the stop time; reduce the cost of protection. Use economical; non-polluting smooth oil; make equipment work more useful.
The FAG active oiler can be investigated according to the detailed application environment; it can also replace the valuable gathering smooth system. It can be used on any equipment: pump; air compressor; fan; conveyor; wheel, etc. Active oiler can use everything Arcanol smooth fat.
Strengths:
Immediately after the installation of the field; immediately write smooth grease to the bearing.
Fully active; no manual protection is required.
Compared with smooth craftsmanship, it saves money.
Operating temperatures range from -10oC to +50oC.
Supply 4 oil filling cycles for selection (1; 3; 6 or 12 months).
The drive can be reused and reclaimed; it is very economical.
Smooth grease containers can be replaced on site.
Anti-corrosion; dustproof; splash-proof (IP65).
The light-emitting transistor shows the working condition (work; standby; fault).
Active smooth; will not mix smoothing agents.
Set the pressure up to 5bar; can beat any block.
The translucent outer casing can often see the amount of smooth grease.
With work and stop switch.
The accessories are universally interchangeable.

Recommend to friends comments close window

Bearing related knowledge

Beijing 130 type automobile shaft guide bearing dismantling method How to repair and repair the bearing repairing method
TIMKEN Roller Bearing Repair Process Rolling Bearing Convention View Preparation Preparation

This article links to http://
Please indicate China Bearing Network http://

Previous:The classification of "rolling bearings" is discussed in the next section: The layout of imported bearings

Three Screw Pump

Three Screw Pump,3 Screw Pump,Three Spindle Screw Pump,Tushaco Three Screw Pump

Hengshui Yuanhan Trading Co.,Ltd , https://www.yuanhanpump.com