Analysis and solution of whitening of injection molded products
| Causes whitening and halo of injection molded products. This is a defect due to contamination of impurities in gas or air. The main solution: (1) Eliminate the interference of gas, and intentionally prevent the contamination of impurities. (2) Increase the material temperature and mold temperature, and adjust the barrel temperature in stages, but prevent the temperature from being too high to decompose. (3) Increase the injection pressure, extend the pressure holding time, and increase the back pressure |
The purpose of door and window sealing strip Pvc Strip,Transparent Pvc Strip is divided into three categories: glass sealing strip (rubber strip), door leaf and door cover sealing strip and wool strip. The glass sealing strip is used for the sealing between glass and leaf and frame, the door leaf and door cover sealing strip is mainly used for the sealing between door panel and door frame, and the wool strip is mainly used for the sealing between frame and leaf. In the production and installation of plastic steel doors and windows, broken bridge aluminum doors and windows and wooden doors, sealing strip is an essential accessory.
The sealant strip plays an important role in waterproof, sealing and energy saving in plastic steel doors and windows, bridge broken aluminum doors and windows and wooden doors and windows, with sound insulation, dust prevention, antifreeze and warmth preservation. It must have strong tensile strength, good elasticity, and good temperature resistance and aging resistance. In order to ensure the fastening of the rubber strip and the profile, the section structure size of the rubber strip must match the profile of plastic steel doors and windows. Sealant strips are generally used for flat doors and windows, suspended windows and folding doors and windows. The main functions are dust prevention, insect prevention, waterproof, sound insulation, sealing, etc.
The installation position of the wool top is generally on the sliding window (door) leaf, the circumference of the frame leaf or the sealing bridge (wind block) to enhance the sealing between the frame and the leaf. Top specification is an important factor affecting the and watertight performance of push-pull doors and windows, and it is also an important factor affecting the switching force of doors and windows. If the wool top specification is too large or the vertical wool is too high, it will not only make assembly difficult, but also increase the moving resistance of doors and windows, especially the initial resistance when opening and the final positioning resistance when closing. If the specification is too small, or the height of the vertical top is not enough, it is easy to fall out of the groove, which greatly reduces the sealing performance of doors and windows.
There are two kinds of tops: silicified and non silicified. The top after silicified treatment has better effect in use. The appearance of the top with qualified quality is that the surface is straight, the bottom plate and vertical hair are smooth and free of bending, and there are no pits on the bottom plate, which meets the requirements of 0.2mm.
Transparent Pvc Strip,Pvc Strip,Aluminium Sliding Strip,Door And Window Sealing Strip
GuangDong XinCheng Material CO.,LTD , https://www.xin-alu.com